Removal and Installation: Installation
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the boss on the valve cover behind the breather with P80 lubricant, or equivalent, before installing the sensor.CAUTION: Failing to add P80 lubricant, or equivalent, could result in O-ring damage and a crankcase ventilation leak.
- Install the crankcase pressure sensor by pressing firmly on the top of the sensor until the o-ring is fully seated.
- Install and tighten the bolt.
- Connect the engine harness to the crankcase pressure sensor.
- Connect the battery or batteries. Refer to Battery Disconnect
.WARNING: Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury;
- Wear appropriate goggles and protective clothing.
- Always properly ventilate the area where the service is being performed.
- Never allow battery fluid to come in contact with skin, eyes, fabrics or painted surfaces.
- To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
- If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.
- Operate the engine and check for leaks.