LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical (CUMMINS 5.0L) (1 Of 2)) >> Removal And Installation >> Camshaft Position Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery or batteries. Refer to Battery Disconnect .
    WARNING: Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury;
    • Wear appropriate goggles and protective clothing.
    • Always properly ventilate the area where the service is being performed.
    • Never allow battery fluid to come in contact with skin, eyes, fabrics or painted surfaces.
    • To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
    • If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.
  2. Disconnect the harness connector from the camshaft position sensor (1).
    GNSALBIA1834Z-834Courtesy of NISSAN NORTH AMERICA, INC.
  3. Remove the bolt (A).
  4. Remove the camshaft position sensor (1).
    CAUTION: Do not reuse the O-ring.