Diagnosis Procedure
Regarding Wiring Diagram information, refer to the appropriate Wiring Diagram .
- CONNECTOR CHECK
Check the AV control unit, audio amp. and speaker connectors for the following:
- Proper connection
- Damage
- Disconnected or loose terminals
Is the inspection result normal?
YES
GO TO 2 .
NO
Repair the terminals or connectors.
- CHECK REAR DOOR SPEAKER SIGNAL CIRCUIT CONTINUITY (AUDIO AMP.)
- Disconnect audio amp. connectors and suspect rear door speaker connector.
- Check continuity between audio amp. connectors and suspect rear door speaker connector.
Audio amp.
Rear door speaker
Continuity
Connector
Terminal
Connector
Terminal
M113
11
D207 (LH)
1
Yes
27
2
12
D307 (RH)
1
28
2
- Check continuity between audio amp. connectors and ground.
Audio amp.
Ground
Continuity
Connector
Terminal
M113
11
-
No
27
12
28
Is the inspection result normal?
YES
GO TO 3 .
NO
Repair or replace harness or connectors.
- CHECK REAR DOOR SPEAKER SIGNAL (AUDIO AMP.)
- Connect audio amp. connectors and suspect rear door speaker connector.
- Turn ignition switch to ACC.
- Push AV control unit POWER switch.
- Check signal between audio amp. connectors and ground.
Audio amp.
Condition
Reference value
Connector
(+)
(-)
Terminal
Terminal
M113
11
27
Audio signal output
12
28
Is the inspection result normal?
YES
Replace rear door speaker. Refer to Removal and Installation .
NO
GO TO 4 .
- CHECK REAR DOOR SPEAKER SIGNAL CIRCUIT CONTINUITY (AV CONTROL UNIT)
- Turn ignition switch to OFF.
- Disconnect audio amp. connector M113 and AV control unit connector M43.
- Check continuity between audio amp. connector M113 and AV control unit connector M43.
Audio amp.
AV control unit
Continuity
Connector
Terminal
Connector
Terminal
M113
24
M43
4
Yes
8
5
23
13
7
14
- Check continuity between audio amp. connector M113 and ground.
Audio amp.
Ground
Continuity
Connector
Terminal
M113
24
-
No
8
23
7
Is the inspection result normal?
YES
GO TO 5 .
NO
Repair or replace harness or connectors.
- CHECK REAR DOOR SPEAKER SIGNAL (AV CONTROL UNIT)
- Connect audio amp. connector M113 and AV control unit connector M43.
- Turn ignition switch to ACC.
- Push AV control unit POWER switch.
- Check signal between AV control unit connector M43 and ground.
AV control unit connector M43
Condition
Reference value
(+)
(-)
Terminal
Terminal
4
5
Audio signal output
13
14
Is the inspection result normal?
YES
Replace audio amp. Refer to Removal and Installation .
NO
Replace AV control unit. Refer to Removal and Installation .