Diagnosis Procedure
Regarding Wiring Diagram information, refer to the appropriate Wiring Diagram .
- CONNECTOR CHECK
Check the AV control unit, audio amp. and speaker connectors for the following:
- Proper connection
- Damage
- Disconnected or loose terminals
Is the inspection result normal?
YES
GO TO 2 .
NO
Repair the terminals or connectors.
- CHECK FRONT DOOR SPEAKER SIGNAL CIRCUIT CONTINUITY (AUDIO AMP.)
- Disconnect audio amp. connector M113 and suspect front door speaker connector.
- Check continuity between audio amp. connector M113 and suspect front door speaker connector.
Audio amp.
Front door speaker
Continuity
Connector
Terminal
Connector
Terminal
M113
15
D12 (LH)
1
Yes
31
2
16
D112 (RH)
1
32
2
- Check continuity between audio amp. connector M113 and ground.
Audio amp.
Ground
Continuity
Connector
Terminal
M113
15
-
No
31
16
32
Is the inspection result normal?
YES
GO TO 3 .
NO
Repair or replace harness or connectors.
- CHECK FRONT DOOR SPEAKER SIGNAL (AUDIO AMP.)
- Connect audio amp. connector M113 and suspect front door speaker connector.
- Turn ignition switch to ACC.
- Push AV control unit POWER switch.
- Check signal between audio amp. connector M113 and ground.
Audio amp. connector M113
Condition
Reference value
(+)
(-)
Terminal
Terminal
15
31
Audio signal output
16
32
Is the inspection result normal?
YES
Replace front door speaker. Refer to Removal and Installation .
NO
GO TO 4 .
- CHECK FRONT DOOR SPEAKER SIGNAL CIRCUIT CONTINUITY (AV CONTROL UNIT)
- Turn ignition switch to OFF.
- Disconnect audio amp. connector M113 and AV control unit connector M43.
- Check continuity between audio amp. connector M113 and AV control unit connector M43.
Audio amp.
AV control unit
Continuity
Connector
Terminal
Connector
Terminal
M113
22
M43
2
Yes
6
3
21
11
5
12
- Check continuity between audio amp. connector M113 and ground.
Audio amp.
Ground
Continuity
Connector
Terminal
M113
22
-
No
6
21
5
Is the inspection result normal?
YES
GO TO 5 .
NO
Repair or replace harness or connectors.
- CHECK FRONT DOOR SPEAKER SIGNAL (AV CONTROL UNIT)
- Connect audio amp. connector M113 and AV control unit connector M43.
- Turn ignition switch to ACC.
- Push AV control unit POWER switch.
- Check signal between AV control unit connector M43 and ground.
AV control unit connector M43
Condition
Reference value
(+)
(-)
Terminal
Terminal
2
3
Audio signal output
11
12
Is the inspection result normal?
YES
Replace audio amp. Refer to Removal and Installation .
NO
Replace AV control unit. Refer to Removal and Installation .