Diagnosis Procedure

Regarding Wiring Diagram information, refer to the appropriate Wiring Diagram .

1. CHECK CONTINUITY OF SIDE CAMERA RH POWER SUPPLY AND GROUND CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect around view monitor control unit connector B83 and door mirror RH connector D107.
   3. Check continuity between around view monitor control unit connector B83 and door mirror RH connector D107.

      Around view monitor control unit		Door mirror RH		Continuity
      Connector	Terminal	Connector	Terminal
      B83	9	D107	19	Yes
      	10		7

   4. Check continuity between around view monitor control unit connector B83 and ground.

      Around view monitor control unit		Ground	Continuity
      Connector	Terminal
      B83	10		No

   Is the inspection result normal?

   YES

   GO TO 2 .

   NO

   Repair harness or connector.

2. CHECK VOLTAGE OF SIDE CAMERA RH POWER SUPPLY 
   1. Connect around view monitor control unit connector B83 and door mirror RH connector D107.
   2. Turn ignition switch ON.
   3. Check voltage between around view monitor control unit connector B83 and ground.

      (+)		(-)	Condition	Voltage (Approx.)
      Around view monitor control unit
      Connector	Terminal
      B83	10	Ground	"CAMERA" switch is ON or shift position is "R".	6.0 V

   Is the inspection result normal?

   YES

   GO TO 3 .

   NO

   Replace around view monitor control unit. Refer to Removal and Installation .

3. CHECK CONTINUITY OF SIDE CAMERA RH IMAGE SIGNAL CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect around view monitor control unit connector B83 and door mirror RH connector D107.
   3. Check continuity between around view monitor control unit connector B83 and door mirror RH connector D107.

      Around view monitor control unit		Door mirror RH		Continuity
      Connector	Terminal	Connector	Terminal
      B83	11	D107	20	Yes
      	12		8

   4. Check continuity between around view monitor control unit connector B83 and ground.

      Around view monitor control unit		Ground	Continuity
      Connector	Terminal
      B83	12		No

   Is the inspection result normal?

   YES

   GO TO 4 .

   NO

   Repair harness or connector.

4. CHECK SIDE CAMERA RH IMAGE SIGNAL 
   1. Connect around view monitor control unit connector B83 and door mirror RH connector D107.
   2. Turn ignition switch ON.
   3. Check signal between around view monitor control unit connector B83.

      Around view monitor control unit			Condition	Reference value
      Connector	(+)	(-)
      	Terminal
      B83	12	11	"CAMERA" switch is ON or shift position is "R".	Courtesy of NISSAN NORTH AMERICA, INC.

   Is the inspection result normal?

   YES

   Replace around view monitor control unit. Refer to Removal and Installation .

   NO

   Replace side camera RH. Refer to Removal and Installation .