LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Intelligent Around View Monitor System) >> DTC/Circuit Diagnosis >> U0428 Steering Angle Sensor >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. ADJUST THE NEUTRAL POSITION OF THE STEERING ANGLE SENSOR 

    When U0428 is detected, adjust the neutral position of the steering angle sensor.

    Perform adjustment of the neutral position of the steering angle sensor. Refer to Work Procedure .

    CAUTION: For vehicles with VDC, adjust the steering angle sensor neutral position on the ABS actuator control unit side.

    GO TO 2 .

  2. PERFORM DTC CONFIRMATION PROCEDURE 

    SYMBOL CONSULT

    1. Turn ignition switch ON.
    2. Erase DTC.
    3. Select "Self Diagnostic Result" mode of "AVM" using.
    4. Check DTC.

    Is DTC U0428 detected?

    YES

    Replace steering angle sensor. Refer to Removal and Installation .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals