Diagnosis Procedure
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to the appropriate Wiring Diagram .
- CHECK FUSE
Check that the following fuses are not blown.
Terminal No.
Signal name
Fuse No.
40
Ignition signal
29 (5A)
Are the fuses blown?
YES
Replace the blown fuse after repairing the affected circuit.
NO
GO TO 2 .
- CHECK POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect around view monitor control unit connector B83.
- Check voltage between around view monitor control unit connector B83 and ground.
Around view monitor control unit
Ground
Condition
Voltage
(Approx.)
Connector
Terminal
B83
40
-
Ignition switch: ON
Battery voltage
Is the inspection result normal?
YES
GO TO 3 .
NO
Repair or replace harness or connectors.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Check continuity between around view monitor control unit connector B83 and ground.
Around view monitor control unit
Ground
Continuity
Connector
Terminal
B83
39
-
Yes
Is the inspection result normal?
YES
Inspection End.
NO
Repair or replace harness or connectors.