Inspection and Adjustment: Inspection
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
Wind Deflector
- Open glass lid assembly fully.
- Visually check for proper installation, damaged/deteriorated components, or foreign objects within mechanism. Correct as required for smooth operation.
- Check for grease at the wind deflector arm (1) and pivot areas. If necessary, apply a sufficient amount of grease for non-binding operation.
: Front
- Check that the wind deflector (1) moves freely within the moonroof unit assembly while manually pressing down and releasing. If a malfunction is detected, remove the moonroof unit assembly and visually inspect; refer to Removal and Installation . If damage is found, replace either wind deflector (1) or moonroof unit assembly as required.
: Front
Link And Wire Assembly
NOTE:
Before replacing a suspect part, make sure it is the source of noise being experienced.
- Check link to determine if coating film has peeled off excessively enough that substrate is visible. Check also to determine if link is the source of noise. Replace as necessary.
- Visually check to determine if a sufficient amount of grease has been applied to wire or rail groove. If not, add grease as required.
- Check wire for any damage or deterioration.