Initialization Procedure

If the moonroof does not open or close automatically, use the following procedure to return moonroof operation to normal.

1. Place the ignition switch in the ON position.
   NOTE: It is best if engine is running during initialization.
2. Fully close the moonroof glass and sunshade by pressing the moonroof switch in the close position.
   NOTE: If required, bump the moonroof switch repeatedly until the moonroof glass and sunshade are completely closed (not in tilt-up position).
3. Press and hold the close switch until the moonroof glass and sunshade operate through several small movements (10 - 20 seconds).
4. Once the moonroof has been motionless for 5 seconds, release the close switch and quickly (within less than a second) press and hold the close switch again. The moonroof glass will cycle to full open and back to close. Hold the close switch until both the moonroof glass and sunshade have completed their movement, then release the close switch.
5. Verify moonroof and sunshade operation by tilting the moonroof glass to vent, opening and closing the moonroof and sunshade.
   NOTE: Repeat this procedure if the moonroof and/or sunshade still do not operate normally. It may be necessary to repeat the procedure up to 5 times. After 5 tries, if the moonroof and/or sunshade still do not operate normally, clear the memory by holding the moonroof switch in the open position for 15 seconds. Then, close the moonroof and sunshade and repeat the initialization procedure.