Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check that the following fuses are not blown:

   Unit	Location	Fuse No.	Capacity
   Headlamp HI (RH)	IPDM E/R	44	10 A
   Headlamp HI (LH)		45

Is the inspection result normal?

YES

GO TO 2 .

NO

Replace the blown fuse after repairing the affected circuit.

With CONSULT

1. Disconnect applicable front combination lamp connector.
2. Turn ignition switch ON.
3. Select "EXTERNAL LAMPS" in "Active Test" mode of "IPDM E/R".
4. While operating the test items, check voltage between applicable front combination lamp harness connector and ground.

   (+)			(-)	Test item		Voltage (Approx.)
   Front combination lamp
   Connector		Terminal
   RH	E61	5	Ground	EXTERNAL LAMPS	Hi	Battery voltage
   					Off	0
   LH	E62				Hi	Battery voltage
   					Off	0

Is the inspection result normal?

YES

GO TO 4 .

NO

GO TO 3 .

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between IPDM E/R harness connector E119 and front combination lamp harness connector E61 and E62.

   Front combination lamp			IPDM E/R		Continuity
   Connector		Terminal	Connector	Terminal
   RH	E61	5	E119	5	Yes
   LH	E62			6

Is the inspection result normal?

YES

Replace IPDM E/R. Refer to Removal and Installation of IPDM E/R .

NO

Repair or replace harness.

1. Turn ignition switch OFF.
2. Check continuity between front combination lamp harness connector terminal 7 and ground.

   Front combination lamp connector		Terminal	-	Continuity
   RH	E61	7	Ground	Yes
   LH	E62

Is the inspection result normal?

YES

Replace the headlamp bulb. Refer to Bulb Replacement .

NO

Repair or replace the harness or connector.