Work Procedure
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK START
- In the cool LED status (wait for more than 10 minutes after turning headlamp OFF), turn ON and turn OFF headlamp several times. Check that headlamp operates normally each time.
- In the cool LED status, turn headlamp ON, wait until headlamp enters the stable status (approximately 5 minutes after turning headlamp ON) and then check that headlamp operates normally without blinking or flickering.
- In the warm LED status (turn headlamp ON for more than 15 minutes and wait for 1 minute after turning OFF), turn ON and turn OFF the headlamp several times. Check that headlamp operates normally each time.
- Turn headlamp ON for approximately 30 minutes and then check that headlamp operates normally without difference in brightness between LH and RH, blinking or flickering.
Is the inspection result normal?
YES
Inspection End.
NO
Refer to Symptom Table .