Detailed Flow
- INTERVIEW FOR MALFUNCTION
Find out what the customer's concerns are.
GO TO 2 .
- SYMPTOM CHECK
Verify the symptom from the customer's information.
GO TO 3 .
- BASIC INSPECTION
Check the operation of each part. Check any concerns that occur other than those mentioned in the customer interview.
GO TO 4 .
- SELF DIAGNOSTIC RESULT WITH CONSULT
Perform the "Self Diagnostic Result". Check that any DTC is detected.
Is any DTC detected?
YES
GO TO 5 .
NO
GO TO 6 .
- TROUBLE DIAGNOSIS BY DTC
Perform the trouble diagnosis for the detected DTC. Specify the malfunctioning part.
GO TO 9 .
- FAIL-SAFE ACTIVATION CHECK
Determine if the customer's concern is related to fail-safe activation.
Does the fail-safe activate?
YES
GO TO 7 .
NO
GO TO 8 .
- SYSTEM DIAGNOSIS
Perform the system diagnosis for the system in which the fail-safe activates. Specify the malfunctioning part.
GO TO 9 .
- SYMPTOM DIAGNOSIS
Perform the symptom diagnosis. Specify the malfunctioning part.
GO TO 9 .
- MALFUNCTIONING PART REPAIR
Repair or replace the malfunctioning part.
GO TO 10 .
- REPAIR CHECK (SELF DIAGNOSTIC RESULT WITH CONSULT)
Perform the "Self Diagnostic Result". Verify that no DTCs are detected. Erase all DTCs detected prior to the repair. Verify that DTC is not detected again.
Is any DTC detected?
YES
GO TO 5 .
NO
GO TO 11 .
- REPAIR CHECK (OPERATION CHECK)
Check the operation of each part.
Does it operate normally?
YES
Inspection End.
NO
GO TO 3 .