LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Door & Lock (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC B2626: Outside Antenna >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to the appropriate Wiring Diagram .

  1. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1 
    1. Turn ignition switch OFF.
    2. Check signal between BCM harness connector and ground using oscilloscope.

      (+)

      (-)

      Condition

      Signal

      (Reference value)

      BCM

      Connector

      Terminal

      M80

      114, 115

      Ground

      When the driver door request switch is operated with ignition switch OFF.

      When Intelligent Key is in the antenna detection area. (The distance between Intelligent Key and antenna: 80 cm or less.)

      GNSJMKIA5955GB-955Courtesy of NISSAN NORTH AMERICA, INC.

      When Intelligent Key is not in the antenna detection area. (The distance between Intelligent Key and antenna: Approx. 2 m.)

      GNSJMKIA5954GB-954Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    Replace BCM. Refer to Removal and Installation .

    NO

    .

  2. CHECK OUTSIDE KEY ANTENNA CIRCUIT 
    1. Disconnect BCM connector and outside key antenna (RH) connector.
    2. Check continuity between BCM harness connector and outside key antenna (RH) harness connector.

      BCM

      Outside key antenna (RH)

      Continuity

      Connector

      Terminal

      Connector

      Terminal

      M80

      114

      D116

      1

      Yes

      115

      2

    3. Check continuity between BCM harness connector and ground.

      BCM

      Ground

      Continuity

      Connector

      Terminal

      M80

      114

      No

      115

    Is the inspection result normal?

    YES

    .

    NO

    Repair or replace harness.

  3. CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 2 
    1. Replace outside key antenna (RH). (New antenna or other antenna)
    2. Connect BCM connector and outside key antenna (RH) connector.
    3. Check signal between BCM harness connector and ground using oscilloscope.

      (+)

      (-)

      Condition

      Signal

      (Reference value)

      BCM

      Connector

      Terminal

      M80

      114, 115

      Ground

      When the driver door request switch is operated with ignition switch OFF.

      When Intelligent Key is in the antenna detection area. (The distance between Intelligent Key and antenna: 80 cm or less.)

      GNSJMKIA5955GB-955Courtesy of NISSAN NORTH AMERICA, INC.

      When Intelligent Key is not in the antenna detection area. (The distance between Intelligent Key and antenna: Approx. 2 m.)

      GNSJMKIA5954GB-954Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    Replace outside key antenna (RH). Refer to Removal and Installation .

    NO

    Replace BCM. Refer to Removal and Installation .