Diagnosis Procedure
- Check Intelligent Key relative signal strength.
- Confirm vehicle Intelligent Key antenna signal strength.
- CHECK INSIDE KEY ANTENNA INPUT SIGNAL 1
- Turn ignition switch OFF.
- Check signal between BCM harness connector and ground using oscilloscope.
(+)
(-)
Condition
Signal
(Reference value)
BCM
Connector
Terminal
M80
123, 124
Ground
When Intelligent Key is in the antenna detection area.
When Intelligent Key is not in the antenna detection area.
Is the inspection result normal?
YES
Replace BCM. Refer to Removal and Installation .
NO
.
- CHECK INSIDE KEY ANTENNA CIRCUIT
- Disconnect BCM connector and inside key antenna (instrument center) connector.
- Check continuity between BCM harness connector and inside key antenna (instrument center) harness connector.
BCM
Inside key antenna (instrument center)
Continuity
Connector
Terminal
Connector
Terminal
M80
123
M84
1
Yes
124
2
- Check continuity between BCM harness connector and ground.
BCM
Ground
Continuity
Connector
Terminal
M80
123
No
124
Is the inspection result normal?
YES
.
NO
Repair or replace harness.
- CHECK INSIDE KEY ANTENNA INPUT SIGNAL 2
- Replace inside key antenna (instrument center) (New antenna or other antenna).
- Connect BCM connector and inside key antenna (instrument center) connector.
- Check signal between BCM harness connector and ground using oscilloscope.
(+)
(-)
Condition
Signal
(Reference value)
BCM
Connector
Terminal
M80
123, 124
Ground
When Intelligent Key is in the antenna detection area.
When Intelligent Key is not in the antenna detection area.
Is the inspection result normal?
YES
Replace inside key antenna (instrument center).
NO
Replace BCM. Refer to Removal and Installation .