LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Body Control System) >> Removal And Installation >> Combination Switch >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before servicing, turn the ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
  • Do not use air tools or electric tools for servicing.
NOTE: Shown with steering wheel removed for clarity only.
  1. Disconnect the battery or batteries. Refer to Battery Disconnect .
  2. Remove the instrument lower panel LH. Refer to Removal and Installation
  3. Remove the steering column covers. Refer to Removal and Installation .
  4. Remove the tilt/telescopic switch electrical connector.
  5. Loosen the combination switch bolts.
  6. Disconnect the harness connector from the combination switch.
  7. Remove the combination switch.

    Combination switch bolts

    : 3.5 Nm (0.36 kg-m, 31 in-lb)
scientia non olet · About LEMON Manuals