Removal and Installation: Installation
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal. Follow the procedure below for specific tightening sequences and procedures.
CAUTION:
- Do not reuse the O-rings.
- Apply A/C compressor oil to the new O-rings for installation.
- After charging the A/C refrigerant, check for leaks. Refer to Leak Test .
- Finger-tighten compressor bolts.
- Tighten compressor bolts to specification in the sequence shown, below.
|
Bolts 1 and 2 |
55.0 N.m (5.6 kg-m, 41 ft-lb) |
|
Bolts 3 and 4 |
61.3 N.m (6.3 kg-m, 45 ft-lb) |