Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION: Do not reuse stabilizer connecting rod nuts.

Position the stabilizer bushings with the slit facing the front of the vehicle.
Align the matching marks when installing.
Tighten the stabilizer connecting rod nut to the specified torque while holding the hexagonal part of the stabilizer connecting rod stud.
Perform the final tightening of the parts under unladen conditions with the tires on level ground.