Rear Wheel Alignment Inspection: Adjustment: Toe-In
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Measure toe-in of rear wheels. If out of specification, inspect and replace any damaged or worn rear suspension parts before adjusting.
Total toe-in
: Refer to Wheel Alignment (Unladen*) .
- Adjust toe-in by turning adjusting bolt on rear lower link.
- After adjusting, tighten adjusting bolt nut to specified torque.
Adjusting bolt nut
: Refer to Exploded View .
CAUTION: When tightening the nut firmly and checking the torque, use a wrench to prevent the turning of the bolt. - After adjusting alignment it is necessary to adjust the neutral position of the steering angle sensor. Refer to Description (WITHOUT ICC) or Description (WITH ICC).