DTC Index

CONSULT display	Malfunction	Reference
CAN COMM CIRCUIT [U1000]	Malfunction is detected in CAN communication. CAUTION: Even when there is no malfunction on CAN communication system, malfunction may be misinterpreted when battery has low voltage (when maintaining 7 - 8 V for about 2 seconds) or 10A fuse [No. 9, located in the fuse block (J/B)] is disconnected.	DTC Diagnosis Procedure
CONTROL UNIT (CAN) [U1010]	Malfunction is detected during the initial diagnosis of CAN controller.	DTC Diagnosis Procedure
VEHICLE SPEED CIRC [B2205]	Malfunction is detected when an erroneous speed signal is input. CAUTION: Even when there is no malfunction on speed signal system, malfunction may be misinterpreted when battery has low voltage (when maintaining 7 - 8 V for about 2 seconds).	DTC Diagnosis Procedure

NOTE: "TIME" indicates the following.

0: Indicates that a malfunction is detected at present.
1-63: Indicates that a malfunction was detected in the past. (Displays number of ignition switch OFF -> ON cycles after malfunction is detected. Self-diagnosis result is erased when "63" is exceeded.)