Diagnosis Procedure

Transmits the washer fluid level switch signal to the combination meter.

1. CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT 
   1. Ignition switch OFF.
   2. Disconnect combination meter connector and washer fluid level switch connector.
   3. Check continuity between combination meter harness connector and washer fluid level switch harness connector.

      Combination meter		Washer fluid level switch		Continuity
      Connector	Terminal	Connector	Terminal
      M24	4	E106	1	Yes

   4. Check continuity between combination meter harness connector and ground.

      Combination meter		--	Continuity
      Connector	Terminal
      M24	4	Ground	No

   Is the inspection result normal?

   YES

   GO TO 2.

   NO

   Repair harness or connector.

2. CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT 

   Check continuity between washer fluid level switch harness connector and ground.

   Washer fluid level switch		--	Continuity
   Connector	Terminal
   E106	2	Ground	Yes

   Is the inspection result normal?

   YES

   Inspection End.

   NO

   Repair harness or connector.