DTC Diagnosis Procedure

The following functions are available when having and carrying electronic ID.

Door lock/unlock
Panic alarm

Remote control entry function and panic alarm function are available when operating the remote buttons.

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to test the remote keyless entry keyfob relative signal strength. Refer to the Signal Tech II User Guide for additional information.

CHECK KEYFOB BATTERY
Check by connecting a resistance (approximately 300Ohm) so that the current value becomes about 10 mA.

Courtesy of NISSAN NORTH AMERICA, INC.

Standard

: Approx. 2.5 - 3.0V

Is the measurement value within specification?

YES

GO TO 2.

NO

Replace keyfob battery.
CHECK KEYFOB FUNCTION
Check keyfob function using Signal Tech II Tool [- (J-50190)] or Remote Keyless Entry Tester [- (J-43241)] (shown).

Courtesy of NISSAN NORTH AMERICA, INC.

Does the test pass?

YES

Keyfob is OK.

NO

Replace keyfob.