Removal and Installation: Removal
- Remove cluster lid A. Refer to Removal and Installation .
- Remove center ventilator grille (RH). Refer to Removal and Installation .
- Remove cluster lid C screws, disconnect harness connector from control unit, then remove cluster lid C from instrument panel and pad assembly.CAUTION: The AV control unit and the front air control use the same 24-pin connector. Caution must be used to prevent misconnection. Colored tape has been added to the wiring harness to identify the connector.
- White = AV control unit
- Green = Front air control
- Remove center ventilator grille (LH) from cluster lid C. Refer to Removal and Installation .
- Remove front air control from cluster lid C. Refer to Removal and Installation - Front Air Control .