Diagnosis Procedure

CHECK FRONT COMBINATION LAMP RH SHORT CIRCUIT TO GROUND

Disconnect front combination lamp RH connector and IPDM E/R connector.
Check continuity between IPDM E/R harness connector and ground.

IPDM E/R			Ground	Continuity
Connector		Terminal
E43		53		No

Is the inspection result normal?

YES

Replace front combination lamp LH. Refer to Removal and Installation and GO TO 2.

NO

Repair or replace harness.

CHECK IPDM E/R DTC
CONSULT.
1. Turn ignition switch ON.
2. Select " Self Diagnostic Result" mode of "IPDM E/R".
3. Check DTC.
Is DTC B20E2-96 detected?

YES

Replace IPDM E/R. Refer to Removal and Installation .

NO

Inspection End.