DTC Confirmation Procedure

1. Turn the ignition switch OFF.
2. Wait for 10 minutes or more.
3. Start the engine.
4. Turn the AEB system ON.
5. Perform "All DTC Reading" with CONSULT.
6. Check if the "C1A21-4B" is detected as the current malfunction in "Self Diagnostic Result" of "LASER/RADAR".

Is "C1A21-4B" detected as the current malfunction?

YES

Refer to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END