Combination Meter: Fail-safe: Fail-Safe

The combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning.

Function		Specifications
Speedometer		Reset to zero by suspending communication.
Tachometer
Engine coolant temperature gauge		The segment turns OFF by suspending communication.
Fuel gauge		Indicates fuel level.
Illumination control		When suspending communication, changes to nighttime mode.
Shift position indicator		The segment turns OFF by suspending communication.
S-MODE indicator
Manual mode indicator
Information display	Door open warning	The display turns OFF by suspending communication.
	Parking brake release warning
	Fuel filler cap warning
	Instantaneous fuel warning	When reception time of an abnormal signal is 2 seconds or less, the last received datum is used for calculation to indicate the result. When reception time of an abnormal signal is more than two seconds, the last result calculated during normal condition is indicated.
	Average fuel consumption
	Average vehicle speed
	Travel distance
Buzzer		The buzzer turns OFF by suspending communication.
Warning lamp/indicator lamp	ABS warning lamp	The lamp turns ON by suspending communication.
	VDC warning lamp
	Brake warning lamp
	Malfunction indicator lamp
	Low tire pressure warning lamp	The lamp turns ON after flashing for 1 minute.
	High beam indicator lamp	The lamp turns OFF by suspending communication.
	Turn signal indicator lamp
	Light indicator lamp
	Rear fog lamp indicator lamp
	Oil pressure warning lamp
	CRUISE indicator lamp
	Key warning lamp
	VDC OFF indicator lamp