Diagnosis Procedure
- CHECK FUSE
Check for blown fuses.
Power source
Fuse No.
Battery (With front door satellite sensor)
6
Battery (Without front door satellite sensor)
11
Ignition switch ON or START
4
Is the inspection result normal?
YES
GO TO 2.
NO
Be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between combination meter harness connector and ground.
Terminals
Ignition switch position
Voltage
(Approx.)
(+)
(-)
Triple meter
Ground
Connector
Terminal
M242
2
Ground
OFF
Battery voltage
3
ON
Is the inspection result normal?
YES
GO TO 3.
NO
Check harness between triple meter and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect triple meter connector.
- Check continuity between triple meter harness connector and ground.
Triple meter
Ground
Continuity
Connector
Terminal
M242
1
Ground
Existed
Is the inspection result normal?
YES
INSPECTION END
NO
Repair harness or connector.