Diagnosis Procedure

Transmits the washer level switch signal to the combination meter.

1. CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect combination meter connector and washer fluid level switch connector.
   3. Check continuity between combination meter harness connector and washer fluid level switch harness connector.

      Terminals				Continuity
      Combination meter		Washer fluid level switch
      Connector	Terminal	Connector	Terminal
      M24	17	E65	1	Yes

   4. Check continuity between combination meter harness connector and ground.

      Terminals			Continuity
      Combination meter		Ground
      Connector	Terminal
      M24	17		No

   Is the inspection result normal?

   YES

   GO TO 2

   NO

   Repair or replace harness or connector.

2. CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT 

   Check continuity between washer fluid level switch connector and ground.

   Terminals			Continuity
   Washer level switch		Ground
   Connector	Terminal
   E65	2		Yes

   Is the inspection result normal?

   YES

   Inspection End.

   NO

   Repair or replace harness or connector.