Diagnosis Procedure

1. Turn ignition switch ON.
2. Measure voltage between the following terminals of the combination meter.

   Terminals			Condition	Voltage (Approx.)
   Combination meter		(-)
   Connector	(+)	Ground
   M24	12		When steering switch is pressed	0 V
   			Other than the above	5 V

Is the inspection result normal?

YES

Inspection End.

NO

GO TO 2

1. Turn ignition switch OFF.
2. Disconnect combination meter connector M24 and combination switch connector M80.
3. Check continuity between combination meter harness connector and steering switch harness connector.

   Combination meter		Combination switch		Continuity
   Connector	Terminal	Connector	Terminal
   M24	12	M80	32	Yes

4. Check continuity between combination meter harness connector and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M24	12		No

Is the inspection result normal?

YES

Inspection End.

NO

Repair or replace harness or connector.