LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (2 Of 4)) >> DTC/Circuit Diagnosis >> DTC P0463: Fuel Level Sensor >> DTC Description >> PR25DD engine >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTC PRIORITY 

    If DTC P0463 is displayed with DTC UXXXX or P0607, first perform the trouble diagnosis for DTC UXXXX or P0607.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable. Refer to DTC Index .

    NO

    GO TO 2.

  2. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is between 11 V and 16 V at ignition switch ON.

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON and wait at least 5 seconds.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Proceed to DTC Diagnosis Procedure .

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals