DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC PRIORITY
If DTC P032B is displayed with DTC P032C or P032D, first perform the confirmation procedure (trouble diagnosis) for DTC P032C or P032D.
Is applicable DTC detected?
YES
Perform diagnosis of applicable.
- P032C: Refer to DTC Description .
- P032D: Refer to DTC Description .
NO
GO TO 2.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 10 V or more at idle.
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start engine and warm it up to normal operating temperature.
- Revving engine from idle up to 3, 000 rpm quickly.
- Repeat the step 2 at 10 times.
- Check DTC.
Is DTC detected?
YES
Refer to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Inspection .
NO
Confirmation after repair: INSPECTION END