LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (2 Of 4)) >> DTC/Circuit Diagnosis >> DTC P0203: Fuel Injector >> DTC Description >> PR25DD engine >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Start the engine and let it idle for at least 30 seconds.
    3. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Proceed to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals