PR25DD engine
WARNING: This page is about a different variant/trim than selected.
- CHECK ENGINE OIL TEMPERATURE SENSOR POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect engine oil temperature (EOT) sensor harness connector.
- Turn ignition switch ON.
- Check the voltage between EOT sensor harness connector and ground.
+
-
Voltage
(Approx.)
EOT sensor
Connector
Terminal
F68
1
Ground
5 V
Is the inspection result normal?
YES
GO TO 3.
NO
GO TO 2.
- CHECK ENGINE OIL TEMPERATURE SENSOR POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between EOT sensor harness connector and ECM harness connector.
+
-
Continuity
EOT sensor
ECM
Connector
Terminal
Connector
Terminal
F68
1
F91
37
Existed
- Also check harness for short to ground.
Is the inspection result normal?
YES
Perform the trouble diagnosis for power supply circuit.
NO
Repair or replace error-detected parts.
- CHECK EOT SENSOR GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between EOT sensor harness connector and ECM harness connector.
+
-
Continuity
EOT sensor
ECM
Connector
Terminal
Connector
Terminal
F68
2
F91
39
Existed
- Also check harness for short to power.
Is the inspection result normal?
YES
GO TO 4.
NO
Repair or replace error-detected parts.
- CHECK ENGINE OIL TEMPERATURE SENSOR
Check the engine oil temperature sensor. Refer to Component Inspection .
Is the inspection result normal?
YES
Check intermittent incident. Refer to Intermittent Incident .
NO
Replace engine oil temperature sensor. Refer to Component Location .