LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (1 Of 4)) >> DTC/Circuit Diagnosis >> P0123 TP Sensor >> DTC Diagnosis Procedure >> PR25DD engine

PR25DD engine

WARNING: This page is about a different variant/trim than selected.
  1. CHECK DTC PRIORITY 

    If P0122 or P0123 is displayed with DTC P0643, first perform the trouble diagnosis for DTC P0643.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable. Refer to DTC Index .

    NO

    GO TO 2.

  2. CHECK THROTTLE POSITION SENSOR 2 POWER SUPPLY 
    1. Turn ignition switch OFF.
    2. Disconnect electric throttle control actuator harness connector.
    3. Turn ignition switch ON.
    4. Check the voltage between electric throttle control actuator harness connector and ground.

      +

      -

      Voltage

      (Approx.)

      Electric throttle control actuator

      Connector

      Terminal

      F57

      2

      Ground

      5 V

    Is the inspection result normal?

    YES

    GO TO 4.

    NO

    GO TO 3.

  3. CHECK THROTTLE POSITION SENSOR 2 POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between electric throttle control actuator harness connector and ECM harness connector.

      +

      -

      Continuity

      Electric throttle control actuator

      ECM

      Connector

      Terminal

      Connector

      Terminal

      F57

      2

      F90

      95

      Existed

    4. Also check harness for short to power.

    Is the inspection result normal?

    YES

    Perform the trouble diagnosis for power supply circuit.

    NO

    Repair or replace error-detected parts.

  4. CHECK THROTTLE POSITION SENSOR 2 GROUND CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between electric throttle control actuator harness connector and ECM harness connector.

      +

      -

      Continuity

      Electric throttle control actuator

      ECM

      Connector

      Terminal

      Connector

      Terminal

      F57

      4

      F90

      90

      Existed

    Is the inspection result normal?

    YES

    GO TO 5.

    NO

    Repair or replace error-detected parts.

  5. CHECK THROTTLE POSITION SENSOR 2 INPUT SIGNAL CIRCUIT 
    1. Check the continuity between electric throttle control actuator harness connector and ECM harness connector.

      +

      -

      Continuity

      Electric throttle control actuator

      ECM

      Connector

      Terminal

      Connector

      Terminal

      F57

      3

      F90

      89

      Existed

    2. Also check harness for short to ground and to power.

    Is the inspection result normal?

    YES

    GO TO 6.

    NO

    Repair or replace error-detected parts.

  6. CHECK THROTTLE POSITION SENSOR 

    Check the throttle position sensor. Refer to Component Inspection .

    Is the inspection result normal?

    YES

    Check intermittent incident. Refer to Intermittent Incident .

    NO

    Replace electric throttle control actuator. Refer to Removal and Installation .