LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Control System (DTC/Circuit Diagnosis) (Pr25DD) (1 Of 4)) >> DTC/Circuit Diagnosis >> P0106 Manifold Absolute Pressure Sensor >> DTC Description >> PR25DD engine >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 1 minute before conducting the next test.

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Accelerate the vehicle from 40 km/h (25MPH) to 70 km/h (44 MPH) or more within 7 seconds.
      CAUTION: Always drive vehicle in safe manner according to traffic conditions and obey all traffic laws.
      NOTE: Keeping the accelerator pedal as steady as possible at approximately 3/8 during the acceleration allows easy diagnosis.
    2. Check DTC.

    Is DTC detected?

    YES

    DTC Diagnosis Procedure 

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals