Component Inspection
WARNING: This page is about a different variant/trim than selected.
- CHECK TRANSMISSION RANGE SWITCH
Check continuity between transmission range switch connector terminals.
Transmission range switch
Condition
Continuity
Terminal
4 - 2
Manual lever: "D" position
Existed
Other than the above
Not existed
4 - 5
Manual lever: "P" position
Existed
Other than the above
Not existed
4 - 6
Manual lever: "L" position
Existed
Other than the above
Not existed
4 - 8
Manual lever: "R" position
Existed
Other than the above
Not existed
4 - 9
Manual lever: "N position
Existed
Other than the above
Not existed
7 - 10
Manual lever: "P" and "N" positions
Existed
Other than the above
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
There is a malfunction of transmission range switch. Replace transmission range switch. Refer to TRANSMISSION RANGE SWITCH : Removal & Installation .