Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Select "RANGE".
4. Shift selector lever.
5. Check that shift position, "RANGE" on CONSULT screen, and shift position indicator display on combination meter are identical.
Is the check result normal?

YES

INSPECTION END

NO

Check "Self Diagnostic Result" in "TRANSMISSION".

NO

Check "Self Diagnostic Result" in "TRANSMISSION".

NO

Check "Self Diagnostic Result" in "METER/M&A".