DTC Detection Logic

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P2813

SELECT SOLENOID

(Select solenoid)

1

Diagnosis condition

--

Signal

--

Threshold

When all the following conditions are established

• DTC other than the applicable DTC is not detected.
• Throttle position: More than 6.27 deg.
• Vehicle speed: Less than 3 km/h (1 MPH)
• CVT fluid temperature: More than 20 deg. C (68 deg. F)
• Shift position: Other than P, N
• Turbine speed when performed N -> D, N (P) -> R: More than 500 rpm
• TCM power supply voltage: More than 11 V
  1. Detection time
     • N -> D: 0.4 seconds
     • N -> R: 0.3 seconds
     • P -> R: 0.3 seconds

Diagnosis delay time

Three times in 1DC

2

Diagnosis condition

--

Signal

--

Threshold

When all of the following conditions are satisfied:

• Shift position: Other than P, N
• Vehicle speed: Less than 3 km/h (1 MPH)
• Differences between primary pulley speed and secondary speed: Less than 120 rpm
• Clutch instructions pressure: 0.95 MPa or more
• Differences between turbine speed and input speed: Less than 200 rpm
• Turbine speed - speed: More than 450 rpm
• DTC other than the applicable DTC is not detected.
• TCM power supply voltage: More than 11 V

Diagnosis delay time

The counting of time continues while all of the following conditions are satisfied and stops when the conditions become unsatisfied (the count is maintained). When accumulated time reaches 30 seconds (Clutch is judged as engaged and the count is reset.)