DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Be careful of the driving speed.
- PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
GO TO 2.
- CHECK DTC DETECTION 1
- Start the engine.
- Maintain the following conditions. (Keep 30 seconds or more after the selector lever shifted.)
Selector lever
: N-> D, N -> R, P-> R
Brake pedal
: Depressed
Engine
: After warming up
- Turn ignition switch OFF and wait for at least 10 seconds.
- Start the engine.
- Perform step 2 again.
- Check the DTC.
Is "P2813"detected?
YES
Refer to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Inspection .
NO
Confirmation after repair: INSPECTION END