LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission (Re0F10D) (DTC/Circuit Diagnosis)) >> DTC Diagnosis >> Transmission (TCM) >> DTC P2758: TCC Pressure Control Solenoid >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Always drive vehicle at a safe speed.
  1. PRECONDITIONING 

    If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

    GO TO 2.

  2. CHECK DTC DETECTION 
    1. Start the engine.
    2. Shift the selector lever to D position.
    3. Fully depress the accelerator pedal and accelerate by reaching 100 km/h (62MPH).

      And then release the accelerator pedal.

      CAUTION: Always drive at a safe speed.
    4. Depress the accelerator pedal half way for 10 seconds.
      CAUTION: Always drive at a safe speed.
    5. Check the first trip DTC.

    Is "P2758" detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals