LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission (Re0F10D) (DTC/Circuit Diagnosis)) >> DTC Diagnosis >> Transmission (TCM) >> DTC P0965: Pressure Control Solenoid B >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. PREPARATION BEFORE WORK 

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    GO TO 2.

  2. CHECK DTC DETECTION 
    1. Start the engine.
    2. Drive the vehicle and maintain the following conditions for 20 seconds or more.

      Selector lever

      : "D" position

      Accelerator pedal position

      : Keep position at 0.8/8 - 1.2/8

      Vehicle speed

      : 40 - 100 km/h (25 - 62 MPH)
    3. Perform step 2 again.
    4. Stop the vehicle.
    5. Turn ignition switch OFF and wait for at least 10 seconds.
    6. Start the engine.
    7. Perform step 2 twice.
    8. Stop the vehicle.
    9. Check the DTC.

    Is "P0965"detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals