DTC Detection Logic

WARNING: This page is about a different variant/trim than selected.

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0841	FLUID PRESS SEN/SW A (Transmission Fluid Pressure Sensor/Switch "A" Circuit Range/Performance)	Diagnosis condition	When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V DTC other than the applicable DTC is not detected. Primary pulley speed: 300 rpm or more Secondary pulley speed: 250 rpm or more Target speed for shifting: Less than 0.1 seconds Pulley ratio: 0.5 - 1.0
		Signal	--
		Threshold	Primary pulley pressure is outside the specified value
		Diagnosis delay time	Maintained for 5 seconds