LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission (Re0F10D) (DTC/Circuit Diagnosis)) >> DTC Diagnosis >> Transmission (TCM) >> DTC P0841: Transmission Fluid Pressure Sen/SW A >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Always drive vehicle at a safe speed.
  1. PREPARATION BEFORE WORK 

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    GO TO 2.

  2. CHECK DTC DETECTION 
    1. Start the engine.
    2. Drive the vehicle and maintain the following condition for 10 seconds or more.

      Selector lever

      : "D" position

      Accelerator pedal position

      : Keep position at 0.8/8 - 1.2/8

      Vehicle speed

      : 80 - 100 km/h (50 - 62 MPH)

      Engine

      : After warming up
    3. Perform step 2 again.
    4. Stop the vehicle.
    5. Turn ignition switch OFF and wait for at least 10 seconds.
    6. Start the engine.
    7. Perform step 2 twice.
    8. Stop the vehicle.
    9. Check the DTC.

    Is "P0841" detected?

    YES

    DTC Diagnosis Procedure 

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals