DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Be careful of the driving speed.
- PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
GO TO 2.
- CHECK DTC DETECTION
- Start the engine.
- Drive the vehicle.
- Maintain the following conditions for 10 seconds or more.
Shift position
: "D" POSITION
Engine speed
: 1, 200 rpm or more
Vehicle speed
: 40 km/h (25 MPH) or more
- Stop the vehicle.
- Check the first trip DTC.
Is "P0793" detected?
YES
Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Inspection .
NO
Confirmation after repair: INSPECTION END