DTC Detection Logic

WARNING: This page is about a different variant/trim than selected.

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0792	INTERMEDIATE SPEED SENSOR A (Intermediate Shaft Speed Sensor "A" Circuit Range/Performance)	Diagnosis condition	When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V After range change completion, it spends 2 seconds or more. Range: D or L Engine speed: 450 rpm or more Input peed: 300 rpm or more Primary pulley speed: 300 rpm or more Secondary pulley speed: 300 rpm or more Lock-up command is being given (except for slip lock-up) DTC other than the applicable DTC is not detected.
		Signal	--
		Threshold	When all of the following conditions are satisfied: Differences between engine speed and primary pulley speed: More than 1, 000 rpm Differences between primary pulley speed and input speed: More than 1, 000 rpm Differences between engine speed and input speed: 1, 000 rpm or less
		Diagnosis delay time	5 seconds