CVT: Re0F10D
WARNING: This page is about a different variant/trim than selected.
- INSPECT CVT BELT
- Remove the control valve (valve body). Refer to CONTROL VALVE : Removal & Installation
.NOTE: Before lifting the vehicle:
- Place the transmission gear selector in Neutral.
- Leave the driver door unlatched.
- Inspect the CVT belt. Refer to Component Inspection .
Is CVT belt OK?
YES
GO TO 2.
NO
GO TO 3.
- Remove the control valve (valve body). Refer to CONTROL VALVE : Removal & Installation
.
- REPLACE CONTROL VALVE
Replace control valve (valve body). Refer to CONTROL VALVE : Removal & Installation .
WORK END
- REPLACE TRANSAXLE ASSEMBLY
- Once CVT replacement is determined, use borescope J-51951 to record a 15 second or less continuous video of the most severe evidence of belt slip and the VIN on the F.M.V.S.S. certification (VIN) label located on B-pillar.NOTE: Attach the video to the Powertrain Call Center CVT Pre-authorization Form prior to calling for authorization. Failure to submit the video will cause denial of request for CVT replacement.
- Completely reassemble the transaxle assembly.
- Replace the transaxle assembly. Refer to TRANSAXLE ASSEMBLY : Unit Removal & Installation (AWD) or TRANSAXLE ASSEMBLY : Unit Removal & Installation (FWD).
WORK END
- Once CVT replacement is determined, use borescope J-51951 to record a 15 second or less continuous video of the most severe evidence of belt slip and the VIN on the F.M.V.S.S. certification (VIN) label located on B-pillar.