DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always drive vehicle at a safe speed.
The MIL is ON and ONLY DTC P0776 (PC SOLENOID B - Pressure Control Solenoid "B" Performance/Stuck OFF) is stored in the TCM.
NOTE:
If this issue should occur, the vehicle may hesitate and/or have a lack of power.
- PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
GO TO 2.
- CHECK DTC DETECTION
- Start the engine.
- Drive the vehicle.
- Maintain the following condition for 20 seconds or more.
Shift position
: "D" position
Vehicle speed
: 40 km/h (25 MPH) or more
Accelerator pedal position
: 1.0/8 or more
- Stop the vehicle.
- Check the first trip DTC.
Is "P0776" detected?
YES
Refer to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Inspection .
NO
Confirmation after repair: INSPECTION END