LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission (Re0F10D) (DTC/Circuit Diagnosis)) >> DTC Diagnosis >> Transmission (TCM) >> DTC P0746: Pressure Control Solenoid A >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Be careful of the driving speed.
  1. PREPARATION BEFORE WORK 

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    GO TO 2.

  2. CHECK DTC DETECTION 
    1. Start the engine.
    2. Drive the vehicle under the following conditions.

      Selector lever

      : "D" position

      Accelerator pedal position

      : 2/8 - 4/8 from 0/8

      Vehicle speed

      : Accelerate to 15 km/h (10 MPH) or more from 0 km/h (0 MPH)
    3. Perform step 2 again.
    4. Stop the vehicle.
    5. Turn ignition switch OFF and wait for at least 10 seconds.
    6. Start the engine.
    7. Perform step 2 twice.
    8. Stop the vehicle.
    9. Check the DTC.

    Is "P0746"detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals