DTC Detection Logic

WARNING: This page is about a different variant/trim than selected.

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0742	TORQUE CONVERTER (Torque Converter Clutch Circuit Stuck On)	Diagnosis condition	When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V Range: D (Except for Manual mode) Accelerator pedal position : 10 deg. or more Engine speed: 450 rpm or more Differences between primary pulley speed and input speed: Less than 50 rpm LU pressure: Less than -0.1 MPa and this state is maintained for 5 seconds Secondary pulley speed: more than 0 rpm and less than 2470 rpm
		Signal	--
		Threshold	Differences between engine speed and input speed: 40 rpm or less.
		Diagnosis delay time	Maintained for 5 seconds or more