LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2019 >> Altima Edition ONE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Automatic Transmission (Re0F10D) (DTC/Circuit Diagnosis)) >> DTC Diagnosis >> Transmission (TCM) >> DTC P0717: Input Speed Sensor A >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Always drive vehicle at a safe speed.
  1. PREPARATION BEFORE WORK 

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    GO TO 2.

  2. CHECK DTC DETECTION 

    SYMBOL With CONSULT

    1. Start the engine.
    2. Drive the vehicle.
    3. Maintain the following conditions for 10 seconds or more.

      Shift position

      : "D" position

      Engine speed

      : 1, 200 rpm or more

      Vehicle speed

      : 40 km/h (25 MPH) or more
    4. Stop the vehicle.
    5. Check the first trip DTC.

    Is "P0717" detected?

    YES

    Refer to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Inspection .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals