DTC Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK CVT FLUID TEMPERATURE SENSOR
- Turn ignition switch OFF.
- Disconnect CVT unit connector.
- Check resistance between CVT unit connector terminals.
CVT unit
Condition
Resistance
(Approx.)
Connector
Terminal
F209
12 - 18
CVT fluid temperature: 20 deg. C (68 deg. F)
6.5 kOhm
CVT fluid temperature: 50 deg. C (122 deg. F)
2.2 kOhm
CVT fluid temperature: 80 deg. C (176 deg. F)
0.87 kOhm
Is the inspection result normal?
YES
GO TO 2.
NO
Replace terminal cord assembly. Refer to CONTROL VALVE : Removal & Installation .
- CHECK CIRCUIT BETWEEN TCM AND CVT UNIT (CVT FLUID TEMPERATURE SENSOR) (PART 1)
- Disconnect the TCM connector.
- Check continuity between TCM harness connector terminals and CVT unit harness connector terminals.
TCM
CVT unit
Continuity
Connector
Terminal
Connector
Terminal
F16
11
F46
18
Existed
12
12
Is the inspection result normal?
YES
GO TO 3.
NO
Repair or replace damaged parts.
- CHECK CIRCUIT BETWEEN TCM AND CVT UNIT (CVT FLUID TEMPERATURE SENSOR) (PART 2)
Check continuity between TCM harness connector terminals and ground.
TCM
--
Continuity
Connector
Terminal
F16
11
Ground
Not existed
12
Is the inspection result normal?
YES
INSPECTION END
NO
Repair or replace damaged parts.